Trace impedance calculator

Most online calculators evaluate a closed-form formula fitted to a handful of cases. This one solves the electromagnetic field of your exact cross-section, copper thickness and solder mask included, with the same field solver we use on our own boards.

Edge-coupled microstrip pair (outer layer)
dielectric εr 4.4planew 0.2s 0.15h 0.2104t 35air
Loss settings
Examples:

How it works

A field solver, not a formula

Your cross-section is cut into small panels along the copper and the dielectric boundaries. The solver computes how charge spreads over them for each way of driving the traces, and impedance, effective permittivity and delay follow from the capacitance it finds.

Running in your browser

The solver is the one we use on our own boards, compiled to WebAssembly: a module of under 200 kB that your browser downloads once and runs locally. Nothing you type leaves the page, and there is no server to wait for.

Where the formula goes wrong

Closed-form formulas are curves fitted to a limited range, and they treat copper thickness roughly. For a 0.2 mm trace pair with a 0.15 mm gap on 0.2104 mm prepreg and 35 µm bare copper, the common formula gives 99.3 Ω differential and the solver 103.6 Ω. With a thinner dielectric the gap can reach 13 %.

What to keep in mind

The result is for an ideal rectangular trace with a constant dielectric. Real boards have etched, trapezoidal traces, resin and glass that vary, and fab tolerances of around 10 %. Use your fab’s stack-up values, and let them confirm the final width.

Want the whole board checked, not just one trace?

The same solvers run through our hardware services: design review, controlled impedance, power integrity and EMC pre-compliance, before the board goes to the fab.